Home Company Products Contacts Site map

products

Klinger® Gaskets > Gasket materials / PTFE Products > KLINGERSIL range > KLINGERSIL C-8200 - Technical data



  Gasket materials / PTFE Products
KLINGERSIL range - KLINGERSIL C-8200
Technical data
 
Klinger cold/hot compression
With this test method developed by Klinger you can evaluate the cold/hot compression of a gasket in cold and
hot condition. Unlike the method acc. to DIN 52913 and BS 7531, the surface load is kept constant during the complete
test so that the gasket is exposed to much tougher conditions.
The thickness decrease at an ambient temperature of 23°C and at heating up to 200°C is measured.
The indicated thickness decrease at 200°C refers to the thickness obtained after loading at 23°C.
 
Typical values for 2 mm thickness
Compressibility ASTM F 36 J % 9
Recovery ASTM F 36 J min % 55
Klinger cold/hot compression thickness decrease at 23°C % 7
25 MPa thickness decrease at 200°C % 17
Density g/cm3 1.7
Acid tests
Thickness increase HNO3, 96%, 18h/23°C % unsuitable
H2SO4, 96%, 18h/23°C % 10
H2SO4, 65%, 48h/23°C % 8
Average surface resistance ROA Ω 8.3x10E9
Average specific volume resistance ρD Ω cm 1.2 x10E10
Average dielectric strength kV/mm 17.5
Average power factor 1kHz, ca.3 mm thickness tan δ 0.27
Average dielectric coefficient 1kHz, ca.3 mm thickness εr 8.4
ASME-Code sealing factors
for gasket thickness 2,0 mm tightness class 1.0 mg/s x m MPa y 15
and tightness classes MPa m 3
DIN 28090 tightness class 0.1 mg/s x m MPa y 22.5
MPa m 4
tightness class 0.01 mg/s x m MPa y 27.5
MPa m 4
 
Dimensions of the standard sheets
Sizes:
1,000 x 1,500 mm,1,500 x 2,000 mm.
Thicknesses:
0.5 mm, 1.0 mm, 1.5 mm, 2.0 mm, 3.0 mm; other thicknesses on request.
Tolerances:
thickness ± 10%, length ± 50 mm, width ± 50mm
 
Rings and other finished gaskets
These gaskets are available in any size and corresponding sheet thicknesses, also edged and PTFEcovered.
 
Surfaces
The standard surface finish of the material is such that the surface has an extremely low adhesion. On
request, graphite facings and other surface finishes on one or both sides are also available.
 
Function and durability
The performance and life of KLINGER gaskets depend in large measure on proper storage and fitting, factors
beyond the manufactor’s control. We can, however, vouch for the excellent quality of our products.
With this in mind, please also observe our installation instructions.
 
Tests and approvals
TÜV Poland.
BS 7531 Grade X.
 
Certified according to DIN EN ISO 9001:2000